Surface thermocouple probe with temperature Range; -73C to 260°C Continuous, 315°C When Used as a "Cement-On" (OMEGABOND® Air Set Cements Available-Place Sensor and Encapsulate with OMEGABOND® Air Set Cement)
Click on this link if you need more information about Thermocouple probes.
The surface thermocouples probes from the SA1XL series achieves
response times of less than
0.15 seconds. This thermocouple is
constructed using a Kapton/fibreglass junction insulation along
with a fibreglass-insulated lead wire.
The SA1XL can be used as a self-adhering
temperatures up to 260°C or
it can be cemented in place for use
at temperatures up to 315°C.
Supplied in convenient packs of 5. All standard models are shown in the "To-Order" table below. Refer to the pdf data sheet for details on ordering non-standard lengths.
† All amounts shown in EUR, GBP, or USD Ordering Example: (1) SA1XL-KI-2M-SRTC Fast Response, Self-Adhesive Type K Thermocouple with 2m Lead and Moulded Mini Thermocouple Plug. Pack of 5., £81.00
Part Number Builder
Build Your Part Number Below
Thermocouple Calibration select from: K for K thermocouple J for J thermocouple T for T thermocouple E for E thermocouple
Wire Length select from: 72 for 2 meter(80 inches) 120 for 3 meter(120 inches) CUSTOM for custom length in inches(121 to 600 inches)
Wire Termination select from: Nothing(leave field blank) for stripped leads -SRTC for male subminiature connector(SMP)
Wire Overbrading select from: Nothing(leave field blank) for no overbrading -SB for stainless steel overbraiding
Note: All combinations may not be valid, check spec sheet for valid part numbers.