Click here if you want to know more about flow meters.
ACCURACY THAT PAYS OFF
In the FP-5200 sensor housing, a magnet is surrounded
by a coil, creating a magnetic field. As the liquid flow
causes the rotor to spin, each blade passing this coil
concentrates the lines of magnetic force, producing a
repeatable AC sine wave output. The FP-5200 also
features OMEGA’s patented "open-cell" rotor, for
increased linearity at ±1% over the full dynamic range
of 1.6 to 20 fps, with negligible head loss.
COMPATIBLE, VERSATILE INTERFACING
The FP-5200 is completely compatible with FPM
Series powered flow indicators, controllers, and
totalizers, to give increased flexibility in system
design. It also interfaces easily with digital computers
and with a variety of other external equipment.
FP-5200 FLOW SENSOR
When you're looking for the added strength of an
all-metal flow sensor, make it the FP-5200. It permits
the high degree of accuracy and reliability you demand,
without added cost. Compare it to traditional metal
flowmeters, where the price increases dramatically
with pipe size. In contrast, you can install the FP-5200
insertion flow sensor in pipe sizes ranging from ½ to
12" without a lot of additional cost, because the sensor
price increases only slightly for larger pipe sizes.
Furthermore, it's accurate to ±1% of full scale.
Installation is easy. Use the FP-5200 locally, or in a
remote area up to 100 feet from the meter or controller
without signal amplification. It needs no external power
or battery. Just one operator, simple tools, an FP-5200
Flow Sensor, a few minutes . . . and you're on-line.
Additionally, the all-stainless-steel flow sensor
accurately measures a wide variety of fluids, even
under high pressure and temperature conditions
[pressures up to 1500 psi, temperatures up to150°C
SPECIFICATIONS Output Signal: Sine wave Output Frequency: 12 Hz per ft/sec, 80 mV peak-to-peak per fps nominal Flow Rate Range: 1.6 fps to 20 fps Output Amplitude: 5 to 8 mV/P-P/Hz Source Impedance: 10 KΩ Accuracy: ±0.2 fps Linearity: ±1% of full range Repeatability: ±0.5% of full range Max Viscosity: 1 centipoise (water); up to 5 cp above 5 fps velocity Materials: Rotor: CD4MCU SS; Rotor Housing: 316 SS; Rotor Shaft: Tungsten Carbide; Transducer Body: 347 SS; Top Flange: 316 SS; Cap 316 SS Rotor Bearing: Fluoroloy B (PTFE-based fluoroplastic) Cable Length: 7.5 m (25'), can be extended up to 30 m (100') with copper wire Maximum % Solids: 10%, with particulate size not exceeding 5 mm cross section or length Weight: 0.9 kg (2 lb)
METAL HOT-TAP FLOW SENSOR
The metal hot-tap sensor allows the user easy sensor
installation and removal without shutting down the
process stream. Compatible with Mueller drill
assemblies, this new hot-tap sensor can be quickly
installed into pipe sizes from 1½ to 24". This hot-tap
assembly is compatible with any 1½ NPT female pipe
fitting such as weldolets and saddles. Installation
fitting not supplied.
SPECIFICATIONS Flow Range: 0.3 to 20 fps Wetted Parts: 316 and CD4MCU stainless steel; FKM and PEEK Power Input: 5 to 24 Vdc @ 10 mA max Max. Pressure/Temperature: 82°C (180°F) up to 250 psig
† All amounts shown in EUR, GBP, or USD Note: Comes complete with operator's manual.