Omega's PR-22 RTD sensor contains an RTD element that meets the
resistance vs. temperature requirements of IEC 60751 making it compatible
with most of the RTD capable measuring products on the market today. With
an M12 connector that is pre-wired with a 4-wire connection, it can be used
in any 2-wire, 3-wire or 4-wire measurement system. Simply use the number of wires
needed for your application.
The PR-22 Moulded M12 connector RTD sensor can be used
in a wide variety of applications as-is, or with one or more complimentary
products such as:
In-line transmitters like the Omega SPRTX-SS series with Integral M12 connector.
Extension cables with silicone, polyurethane or PVC insulation and straight or right angled connectors.
Contollers and panel meters.
Stainless steel or brass compression fittings.
† All amounts shown in EUR, GBP, or USD Note: M2 only available in 150 mm and
250 mm lengths Ordering Example: (1) PR-22-3-100-A-M6-150-M12 Pt100 Class A RTD sensor with 6 mm diameter by 150 mm long probe stem and moulded 4-pin M12 connector., £42.00
Part Number Builder
Build Your Part Number Below
Element Specification select from: 100-A for Pt100 Class A 100-B for Pt100 Class B
Probe diameter select from: -M2 for 2 mm diameter probe -M3 for 3 mm diameter probe -M6 for 6 mm diameter probe
Probe length select from: -100 for 100 mm probe length (3mm or 6mm diameter) -150 for 150 mm probe length (2mm 3mm or 6mm diameter) -250 for 250 mm probe length (2mm 3mm or 6mm diameter) -350 for 350 mm probe length (3mm or 6mm diameter) -500 for 500 mm probe length (3mm or 6mm diameter) -750 for 750 mm probe length (3mm or 6mm diameter) -1000 for 1000 mm probe length (3mm or 6mm diameter)
Note: All combinations may not be valid, check spec sheet for valid part numbers.